Ahmad Raza
, Amjad Khatak
The demand for electricity is rising. speedily and installation of latest transmission lines is tough owing to factors relating to the environment and conjointly its not economical specially in full space wherever right of means is a problem as putting in new lines decrease the change of state of the world. In Asian nation the put in capability is bigger than the overall demand, the most reason is that the poor gear mechanism and therefore the power flow capability of the prevailing conductor to be exaggerated that is completed by victimization compensation devices. Recently, new advancement in versatile AC gear mechanism (FACTS) technology that is employed for reactive power compensation. Static synchronous series compensator belongs to FACTS family. It controls the flow of power in conductor and injects the voltage in construction with the conductor current. During this analysis, a 132 potential unit conductor returning from Kohat grid station to Gurguri grid station is chosen as a check system as a result of there a voltage stability issue and high demand in summer months of June, July and august throughout now the losses will increase and cargo shedding phenomena become a typical issue. to realize voltage stability and enhance power flow within the network Static Syunchrouns Series Compensation (SSSC) technique has been during this analysis work. The check Simulink is used to simulate the model. for varied situations and therefore the results of active power ,voltage , current are examined while not victimization SSSC and with SSSC within the check system. The check system was conjointly simulated underneath a typical 3 section contact fault and therefore the result shows that by victimization SSSC the oscillations damped terribly compared to the circuit, fast while not victimization SSSC and therefore the Stability is preserved.
Ahmad Raza Amjad Khatak “Power Flow Control using Fact Devices in Power System with Simulkink Software” International Journal of Engineering Works Vol. 8 Issue 10 PP. 249-261 October 2021 https://doi.org/10.34259/ijew.21.8010249262.
[1] Prof.R.M. Malkar, Prof.V.B.Magdum, “Recent Trends in Real and Reactive Power flow Control with SVC and STATCOM Controller for transmission line,” IJAIEM, March 2015.
[2] M.Maheskumar, “A study of reactive power compensation in power system and its compensation techniques” International journal of innovations in engineering and technology, 2015.
[3] S.S.Patil, Manasa.N.R, P.Anaji, “Power Quality Improvement using SSSC” International Journal of Emerging Research in Management &Technology, May 2014.
[4] Y.H.Song and A.T.Johns, "Flexible ac transmission systems (FACTS)," The Institution of Electrical Engineers 1998.
[5] N.G.Hingorani and L.Gyugyi, “Understanding FACTS: concepts and technology of flexible AC transmission systems,” IEEE Press, 2001. B
[6] K S Apremeya, Veena “Voltage Profile Improvement of Transmission Line Using SSSC” International Journal of Scientific Development and Research (IJSDR) Volume 2, Issue 1 January 2016.
[7] M.H.Haque“Stability Improvement by Facts devices: A Comparison between STATCOM and SSSC”IEEEPower Engineering Society Meeting, 2004.
[8] G.Saraswathi, Dr.N.Visali, B.N.Reddy, “Power flow improvement using Static Synchronous Series Compensator (SSSC)” International Joural of Engineering Studies and Technical Approach.
[9] Sedighizadeh, M.Toulabi, M.S.Rezazadeh, A.Khatibi, “Damping Improvement by SSSC and STATCOM in a Part of Iran Electrical Network” 43rdUniversities Power Engineering International Conference, 2009.
[10] A.Haleem, R.Malgireddy, “Power Flow Control with Static Synchronous Series Compensator (SSSC)” Proc. of the International Conference on Science and Engineering (ICSE 2012)
[11] P.Dhoble, A.Bhandakkar, “Review of Active Reactive Power Flow Control Using Static Synchronous Series Compensator (SSSC)” INTERNATIONAL JOURNAL OF INNOVATIVE RESEARCH & DEVELOPMENT, April, 2013.
[12] Zenk, H. Akpinar, A.S. “PI, PID and Fuzzy Logic Controlled SSSC Connected To a Power Transmission Line, Voltage Control Performance Comparison” 4th Intl Conference on Power Engineering, Energy and Electrical Drives, 2014.
[13] A.A.Nimje, C.K.Panigrahi and A.K.Mohanty, “Enhanced power transfer capability by using SSSC” Journal of Mechanical Engineering Research Vol. 3 (2), pp. 48-56, February 2012.
[14] Sen, K.K. “SSSC, Theory, Modelling and Application” IEEE Transactions on Power Delivery” (Volume: 13, Issue: 1) Pages 241 – 246.
[15] M.S.E.Moursi and A.M.Sharaf“Novel Controllers for the 48-Pulse VSC STATCOM and SSSC for Voltage Regulation and Reactive Power Compensation” IEEE TRANSACTIONS ON POWER SYSTEMS, VOL. 20, NO. 4
[16] Rizan A. Ali, Ergun Ercelebi “Improve Power Stability & Damping Oscillation in Multi Machine System Using (SSSC) with POD Controller” International Journal of Computing, Communications & Instrumentation Engineering (IJCCIE) Vol. 3, Issue 2 (2016).
[17] P. Dhoble, A. Bhandakkar “Active Reactive Power Flow Control Using Static Synchronous Series Compensator (SSSC)” IOSR Journal of Electrical and Electronics Engineering (IOSR-JEEE) e-ISSN: 2278-1676,p-ISSN: 2320-3331, Volume 7, Issue 6 (Sep. - Oct. 2013)
[18] S.S.Patil, Manasa.N.R, P.Anaji “Power Quality Improvement using SSSC” International Journal of Emerging Research in Management &Technology ISSN: 2278-9359, May 2016
[19] M.Thangavel, S.Shiny Jasmine “Enhancement Of Voltage Stability And Power Oscillation Damping Using Static Synchronous Series Compensator With SMES” International Journal of Advanced Research in Technology Vol. 2 Issue 3, March 2012
