The desire and required place for providing electricity i.e. Homes, industries, markets, etc. are far away from the place where electricity is produced (power stations). It results in low efficiency and also increases the cost. It has so many dis-advantages. It may also have environmental and security issues as well. The primary objective of this resaerch is to evaluate and reduces the percentage loss. The power loss is performed for different locations. The result shows the appropriation of distributed generator in to power system.
-
Mushtaq A.K.Khattak,
,
University of Engineering and Technology, Peshawar,
Pakistan.
-
Amjadullah khattak,
,
University of Engineering and Technology, Peshawar,
Pakistan.
-
Mohammad Ismail,
,
University of Engineering and Technology, Peshawar,
Pakistan.
-
Waqar Hussain,
,
University of Engineering and Technology, Peshawar,
Pakistan.
-
Jahangir Bahadur,
,
University of Engineering and Technology, Peshawar,
Pakistan.
-
Najum Saqib,
,
University of Engineering and Technology, Peshawar,
Pakistan.
Mushtaq.A.K.Khattak Amjadullah khattak Mohammad Ismail Waqar HussainJahangir Bahadur and Najum saqib Power Loss Analysis of a Radial Distribution Feeder by using Distributed Generator International Journal of Engineering Works Vol. 6 Issue 08 PP. 249-252 August 2019
- [1] K. Dang, J. Yu, T. Dang, and B. Han, “Benefit of distributed generation on line loss reduction,” in 2011 International Conference on Electrical and Control Engineering, 2011, pp. 2042-2045.
- [2] A. Kumar and W. Gao, “Voltage profile improvement and line loss reduction with distributed generation in deregulated electricity markets,” TENCON 2008 - 2008 IEEE Region 10 Conference, pp. 1-6, Nov. 2008.
- [3] P. Chiradeja, “Benefit of Distributed Generation: A Line Loss Reduction Analysis,” in 2005 IEEE/PES Transmission & Distribution Conference & Exposition: Asia and Pacific, pp. 1-5.
- [4] Sonderegger, R. C., Henderson, D., Bubb, S., and Steury, J.,“Distributed Asset Insight,“ IEEE Power&Energy Magazine, pp. 32-39, May/June 2004.
- [5] Puttgen, H. B., Macgregor, P. R., and Lambert F.C., “Distributed Generation: Semantic Hype or the Dawn of a New Era?,” IEEE Power&Energy Magazine, pp. 22-29, January/February 2003.
- [6] A. D. T. Le, M. A. Kashem, S. Member, M. Negnevitsky, and G. Ledwich, “Optimal Distributed Generation Parameters for Reducing Losses with Economic Consideration,” pp. 1-8, 2007.
- [7] P. Chiradeja, R. Ramakumar, and L. Fellow, “An Approach to Quantify the Technical Benefits of Distributed Generation,” vol. 19, no. 4, pp. 764-773, 2004.
- [8] R. Abbasi, “Reduction of Transmission Line Losses Using VLSI Interconnect,” Procedia Engineering, vol. 30, no. 2011, pp. 10-19, Jan. 2012.
- [9] T. Q. D. Khoa, P. t. t. Binh, and H. b. Tran, “Optimizing Location and Sizing of Distributed Generation in Distribution Systems,” in 2006 IEEE PES Power Systems Conference and Exposition, 2006, pp. 725-732.
- [10] H. Iyer, S. Member, S. Ray, S. Member, R. Ramakumar, and L. Fellow, “Assessment of Distributed Generation Based on Voltage Profile Improvement and Line Loss Reduction,” pp. 1-6, 2010.
- [11] P. A.-d-vimal Raj, S. Senthilkumar, J. Raja, S. Ravichandran, and T. G. Palanivelu, “Optimization of Distributed Generation Capacity for Line Loss Reduction and Voltage Profile Improvement Using PSO,” vol. 10, no. 2, pp. 41-48, 2008.
- [12] W.-T. Huang and S.-T. Chen, “Line Loss Reduction by Distribution System Upgrading from Radial to Normally Closed-Loop Arrangement,” 2009 Ninth International Conference on Hybrid Intelligent Systems, pp. 334-339, 2009.
- [13] H. B. Puttgen, P. R. Macgregor, and F. C. Lambert, 2003. Distributed generation: Semantic hype or the dawn of a new era?. vol. 1, p. 22-29. Power and Energy Magazine, IEEE.
- [14] R. K. Rajput, 2005. Internal Combustion Engines: Laxmi Publications.
- [15] D. M. Tagare, 2011. Electricity Power Generation. The Changing Dimensions: Wiley
